Next, duplicate the circle, paint over black and resize it so that the new circle fits into the outer ring of the gray circle. Then duplicate the black circle again. Resize the copy so that it is slightly smaller than the black circle.
While holding down the Ctrl key, click on the thumbnail of the layer of the last circle to create a selection outline. Without touching the outline, delete the layer with which it was created, and then select the larger, darker circle below. Now press the Delete key to delete the center of the circle and leave only the ring. Repeat this process until you have created all the rings.
Having created all the wheel circles, as in the image of a real airplane, block the layers that make up the landing gear. After that, use a soft round brush to add simple shadows and small areas of rust, as shown in the figure: Continue reading
While holding down the CTRL key, click on the “ribbon front” layer to select it. Then create two layers named “ribbon front left refl” and “ribbon front right refl” on top of the “PREMIUM QUALITY” text layer.
Applying the same technique that we used earlier, subtract the necessary areas of selection with the Oval Tool, as shown in the figure. Then fill the selection with white:
Reduce the “Opacity” of both layers to 20%:
While holding down the CTRL key, click on the “shield outer” layer to select it. Create a new layer under it called “shield shadow”, and fill the selection with black. Then, using the command Edit> Transform Path> Zoom, squeeze the black shape down: Continue reading